Fan Assembly. Pgs - Craftmade Leeward LW52 Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to
use.Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely.
Locate canopy cover and anti-sway adapter in
hardware packs. Slide yoke cover, canopy cover,
anti-sway adapter and canopy over downrod.
to diagram 3.] (Note: Canopy cover must be turned
with shiny side toward motor housing. If using the
anti-sway adapter, it must be turned with flat side
toward the canopy.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop
pin into top of downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
[Refer to diagram 4.]
WARNING: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
[Refer to diagram 2.]
[Refer
page 4
set screw
diagram 1
downrod
clip
diagram 2
downrod
canopy
yoke cover
diagram 3
stop pin
diagram 4
stop pin
hanging ball
yoke set
screw
and nut
pin
anti-sway
adapter
canopy cover
motor
housing
set screw hole
hanging
ball