Canopy Assembly; Blade Assembly - Craftmade Leeward LW52 Guia De Instalacion

7. Canopy Assembly.

Remove 2 screws on underside of hanging bracket.
Lift canopy to hanging bracket. Align holes in
canopy with holes in hanging bracket. While holding
canopy in place, slide anti-sway adapter up to
canopy. Align holes in anti-sway adapter with holes
in bottom of canopy and then re-insert the screws
that were previously removed. Tighten both screws
securely.
Slide canopy cover up to anti-sway adapter, aligning
rounded part of slotted holes in canopy cover with
screw heads in bottom of anti-sway adapter. Turn
canopy cover to the right (clockwise) until it stops.

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble
the blades. If overtightened, blades may crack
and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
canopy
anti-sway
adapter
plastic
motor lock
lock washers
page 6
hanging bracket
screw
canopy cover
motor housing
blade arm
blade arm screws
blade