Rack Mounting; Setting The Mode Switches; Setting Clip Limiters - QSC CX108V Manual Del Usuario

RACK MOUNTING

Optional handles shown. Use four screws and washers to mount
the amplifier to the equipment rack rails. To use the
amplifier outside a rack, attach the self-adhesive
rubber feet to the bottom.
EN
COOLING
Air flows from the rack, into the back of the amplifier, and out
the front. This keeps the rack cool. The fan automatically runs
faster when the amp is working hard.
Do not block the front or rear air vents!
AC MAINS
Connect AC power to the IEC socket on the back of the ampli-
fier. NOTE: Turn off the AC power switch before connecting AC
power. The AC Switch must be turned on to use remote control
systems or the Standby function.

SETTING THE MODE SWITCHES

The CX108V has four 2-channel amplifiers in one chassis. Each
of the 2-channel pairs has its own DataPort and mode
switches for Stereo, Parallel, or Bridge mode. The channel
pairs are: Ch. 1-2, Ch. 3-4, Ch. 5-6, Ch. 7-8. Each channel has
independent clip limiting and low frequency (LF) filtering.

SETTING CLIP LIMITERS

Each channel has a clip limiter with its own on-off switch. The
limiter only responds to actual clipping, and automatically
compensates for load and voltage variations. Clip limiting is
generally recommended, especially to protect high frequency
drivers.
Set switch UP to use Clip Limiting.
Switch 1 controls the first channel.
Switch 10 controls the second channel.
4
Air flow in QSC amplifiers: Cool air is drawn
into the rear of the amplifier by the cooling fan.
Warm air exits the front of the amplifier.
The correct AC line voltage is shown on the serial
number label, on the rear panel. Connecting to the
wrong line voltage may damage the amplifier or
increase the risk of electric shock.