QSC PLD Serie Guide De Mise En Route Rapide página 8

Preset izard
The Preset Wizard simplifies the preset creation process, allowing you to create a preset from the ground up. The Preset Wizard first asks you to
designate the desired power levels and load impedances; from that information it will assign a suitable amplifier configuration. Then you may select
and assign loudspeakers to each output.
HOME > PRESETS > PRESET WIZARD > ENTER
STEP 1 — About the PRESET WIZARD
ABOUT
Preset Wizard does the following:
• Configures the amplifier
• Loads DSP settings for assigned speakers
Tips:
• Start with the highest power
• Speakers do not need to be assigned
to each output
STEP 2 — Adjust Impedance and Power
EN
OUTPUTS
Output:
Imped:
Power:
Remaining Power Available: 1875 W
Enter Load Profile (Impedance and Power)
HOME > PRESETS > PRESET WIZARD > ENTER > (ENTER)
Possible Output Mode Combinations using the Preset Wizard
A B C
- - - - - - - - -
*
25% 25% 25%
*Percentages are used to represent the power for different amplifier models.
STEP 3 — Select Output Channel for Speaker Assignment
OUTPUTS
Output:
Imped:
Power:
Spkr:
TD-000351-00-E
SPEAKERS SAVE
NEXT
SPEAKERS SAVE
A B C
8.0 - - - -
625 - - - -
D AB C D AB
- - - - - - - - - - - - - - -
25% 50% 25% 25% 50%
Modes: A B = Separate Channels / A+B = Bridge Mode / AB = Parallel Mode
SPEAKERS SAVE
A B C
8.0 8.0 8.0
625 625 625
- - - - - - - - - - - -
Assign Assign Assign Assign
Preset Wizard does the following:
• Configures the amplifier
• Loads DSP settings for
assigned speakers
Tips:
• Start with the highest power
• Speakers do not need to be
assigned to each output
Adjust impedance based on the total
loudspeaker load connected to the
D
channel.
Default = 8 Ω
- -
Default = min. for amp
- -
Impedance and power settings are
dynamically linked.
CD A+B C D A+B
- - - - - - - - - - - - - - -
50% 50% 25% 25% 50%
— Figure 15 —
When you are finished setting
the impedance and power for
D
each output, scroll to the
8.0
SPEAKERS tab.
625
Loudspeaker assignment is
optional. You may assign a
- - - -
loudspeaker to one or more
channels, or none at all.
8
To continue, press
Scroll to select (Impedance or Power)
Turn to adjust parameter
To confirm, press
Repeat for remaining
output channels
C+D ABC D AB + CD
- - - - - - - - - - - -
50% 75% 25% 100%
Scroll to select the output channel.
To assign a loudspeaker, press
Continue to the next step.
ENTER
To edit, press
ENTER
ENTER
ABCD
- - -
100%
ENTER