Garland BGS 2400 Manual De Instruccion página 19

• Make sure that the machine is steady. When inserting the materials to grind,
do not get too close and never stand in a higher position than the shredder.
• When inserting the waste, make sure that there are no other hard objects like
metal, stones, glass or other foreign objects.
• Do not use the machine with rain or bad weather, always work with daylight or
in a place very well illuminated.
• Do not use the machine if you are tired, or if you are under the influence of
alcohol or medicines. Work with moderation.
• Turn the machine off and remove the plug:
- during breaks and when not using the machine.
- before carry out any work on the machine (cleaning or maintenance work).
- when the extension cable is deteriorated or entangled.
- when the machine is blocked.
- when you try to move or to lift up the machine.
- when there is a foreign object in the machine and if unusual noises or vibrations
take place (check that the machine is not damaged before using it again).
• Do not allow used materials to get accumulated in the exit area; as the
shredded material would clog the exit area and could eventually block the
entrance orifice.
• Do not transport or turn the machine with the engine on.
• Do not stop the machine until it is completely empty, otherwise the shredder
could get blocked and it would not work again.
• Do not try to repair the machine yourself, unless you have been specifically
trained to do so. Any other work that has not been mentioned in this instruction
manual should be carried out by an authorized technical service.
Electrical security
• Remove the plug immediately if the cable feeder spoils while in use. Do not
touch the cable and do never work with a damaged cable.
• Only use authorized cable extension, protected against water to work
outdoors. The cable extension must have a 1,5 mm
length shorter than 25 m and 2,5 mm
When you use the machine the extension cable must be fully extended. Check
2
2
section if the length is longer than 25 m.
19
section for a cable with a