Setting The Group Index Number - Sony PC-3000 Manual De Instrucciones

Adjustments and Settings on the Display Window
7
Adjust other items according to the steps 5 and 6.
8
Press the SET button to enter the setting.
The following message appears.
EXB So n G OUT
>YES >NO
9
Press the ? or / button to select the setting.
To output the Sync on G signal: flash YES.
Not to output the Sync on G signal: flash NO.
10
Press the SET button to enter the setting.
Resetting the preset levels
1
Press the ? and / buttons simultaneously for at
least five seconds when the display for adjusting
the COLOR, HUE and SHARP appears (in step 4).
The RESET display appears.
RESET ALL DATA? S
>YES >NO
2
Press the ? or / button to flash YES.
3
Press the SET button to enter the setting.
Notes
In the following cases, the EXB CONTROL display
does not appear:
• When the RGB/MIX switch of the IFB-12/12A is not
set to RGB.
• When you select a channel which you cannot control
on the extension board.
20
(EN)

Setting the Group Index Number

You can set the group index number of this unit.
The factory setting of the group index number is No. 01.
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU GP INDEX SETTING display appears.
CONTROL MENU
GP I NDEX SETT I NG
4
Press the SET button.
The GP INDEX SETTING display appears.
GP I NDEX SETT I NG
No. 01
5
Set the index number.
You can set the number between 1 and 99.
> or / button: press to increase the number.
. or ? button: press to decrease the number.
GP I NDEX SETT I NG
No. 02
6
Press the SET button to enter the setting.