Sol Welding QUAD Serie Manual De Instrucciones página 77

Instruction Manual
NOTE: the double Puls starts at the end of the first up slope and it
finishes when you press the torch switch and ends the high puls
time. The information on the double Puls can be modified by the
user. They can even differ within the same programme, if they are
memorized in the jobs.
Adjustment of the DOU-
BLE PULS FREQUENCY
NOTE: it can be regulated
only if the programme is
set on SYN or PULS.
1. Press the know (91)
until the Led (84)
turns on.
2. Regulate the Double
Puls frequency using the
knob (91) from off to the
wanted value.
NOTE: the jobs are preset programmes for the user. Each pro-
gramme can contain up to 9 jobs. When you select a job the corre-
sponding parameter will be shown in the frontal panel. These para-
meters are preset in the job itself.
QUAD AC/DC SERIES
Selection of
JOB N°
1. Press the know (90)
until the Led (89) turns
on.
2. Select the programme
number using the knob
(90). (See Chap. 13 JOBS
SAVING to page 39).
35 GB
GB