Selecting the Operational Options of Remote Control
Muting a pip tone
When you press the buttons on the remote control, a pip tone is issued except for the A.C.BASS and VOLUME +, – buttons.
To mute the pip tone, in Stop mode or during playback, press and
hold the A.C.BASS button, and within one second, press the P.MODE
button. "BEEP OFF" scrolls on the remote control's display.
To resume a pip tone, do the same operation again. "BEEP ON"
will scroll on the display.
Note
If the P.MODE button is not pressed within one second, Sound mode will changed.
Changing the Display Character Contrast
The character display contrast can be adjusted when the characters become less clear due to ambient temperature or
during scrolling. In Stop mode or during playback, press and hold the A.C.BASS button and, within one second,
press the 4 or ¢ button.
Adjustment can be made between LCD00 and LCD15. While the
4 or ¢ button is pressed, the contrast will be changed continu-
ously. The initial setting is "LCD10".
Note
If the 4 or ¢ button is not pressed within one second, Sound mode will be changed.
Preparation Before Recording
Connection for recording
Connect one of the following music sources to the unit.
• Analog input to the LINE IN (OPTICAL) jack
• Digital input to the LINE IN (OPTICAL) jack
• Microphone input to the MIC (PLUG IN POWER) jack
Notes
• You cannot mix the microphone sound with the LINE IN source.
• Since the priority for each input is as follows, be sure to disconnect the other music source before recording. For
example, disconnect the microphone before recording an analog input.
Digital input (LINE IN) > MIC input > Analog input (LINE IN)
Things to know before you start recording
• It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.
• Carefully read the "Rules of Digital Dubbing" on page 18.
• The MD recorder supports the following sampling frequencies for digital source, LINE IN (OPTICAL).
32 kHz, 44.1 kHz and 48 kHz
• When recording a digital input or microphone input, the recording level is automatically set correctly. When re-
cording an analog input, it is necessary to adjust the recording level properly. Recording is not affected by the
A.C.BASS or tone level setting.
• The accidental erasure prevention knob is provided on the back of an MD cartridge to prevent accidental erasure
or recording. It must be set to the close position before recording or editing.
• Remote control operation will be disabled during record-
ing or editing.
• Unplugging or plugging of the connection cord or micro-
phone should be avoided during recording.
• Removal of the rechargeable battery should be avoided
during recording. Otherwise, you cannot open the lid un-
less the rechargeable battery is reinserted or AC adaptor is
connected to the unit.
Stereo connection cable (not supplied)
Optical digital cable (supplied)
A.C.BASS
(Within 1 second)
(Press and hold)
A.C.BASS
(Within 1 second)
(Press and hold)
Microphone (not supplied)
Accidental erasure prevention knob
Close
For recording
or editing
or
MD player,
tape deck, etc.
CD player, etc.
Open
For protecting
erasure
8