Series Recording; Recording After Power Interruption Or Moisture Condensation - Sony SVT-L230P Manual De Instrucciones

Recording

Series Recording

Connect another SVT-L230P for series recording (for
details on connection, see page 9) and set each of the
units as follows.
Item Unit #1
SERIES REC on Y
SET UP 3 screen
TAPE END OUT on –3M
SET UP 3 screen
Cassette tape Loaded
Operating status Recording Turned off Turned off
REPEAT REC OFF
Security lock Locked
Timer recording OFF
When all of the settings are complete, set unit #1 in
recording mode and turn off the power of unit #2 and
subsequent unit.
When recording on unit #1 is complete, the power for
unit #2 turn on and recording begins (The recording
cannot be done for about 11 seconds.).
The unit #1 rewinds its tape and turns off.
When a E-180 or E-240 tape is used and TAPE END
OUT is set to –3M, the unit #2 starts recording before
the unit #1 stops so that recording is continued without
stop.
18
Unit #2 Unit #3 and
subsequent
unit
Y Y
–3M –3M
Loaded Loaded
OFF OFF
Locked Locked
OFF OFF
Recording after Power Interruption
or Moisture Condensation
If a power interruption occurs, The P indicator lights in
the display window and if a moisture condensation
occurs, the "dddd" indicator flashes. Even if a power
interruption or moisture condensation occurs while
recording, the internal batteries provide backup power
for memory for at least 30 days. The internal batteries
can be charged in about 48 hours.
If the power is interrupted during recording, the
recording starts automatically after power is restored.
To check power interruptions or moisture
condensation
Press MENU until POWER FAILURE/DEW display
appears.
This shows a count of the power interruption and
moisture condensation and the period when the
recording was interrupted.
Count of power interruption
<POWER FAILURE>
002 FAILURE 20-12
RECOVERY 20-12
<DEW>
001 FAILURE 10-12
RECOVERY 20-12
Count of moisture condensation
MENU
07:15
07:30
No recording
periods
11:00
12:00