Graco Direct Connect 2M17 Manual Del Dueño página 4

Parent Unit
seconds. If operated too long on a low battery, you may also experience a poor signal
and the no connection symbol
series of 2 audible beeps every 10 to 15 seconds.
hear the Parent Unit beep.
symbol
audible beeps every 10 to 15 seconds to warn the user that the connection to the
Nursery unit has been lost.
the audible beep will stop.
1. For optimum operation, it is best to charge the batteries in the Parent Units for at least 16 hours prior
to use. The rechargeable batteries need to be installed into the Parent Unit before charging - refer to the
2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the
back of the Nursery Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block
sound transmission.
4. Place the Parent Unit within five (5) feet (1.5 meters) of the Nursery Unit and turn on the Parent Unit
5. Turn on the Nursery Unit using the On/Off button on the front of the unit.
6. Within a few seconds, the Parent Unit will lock on to the Nursery Unit.
A second later, you will hear a series of beeps and the connection symbol should
If the symbol shows, the Parent Unit is out of range of the Nursery Unit.
pressing power button for 2 seconds until it beeps, then
DO NOT put temperature sensor near a heat source or air conditioning vent.
We have added the thermometer for your convenience. Ambient temperature readings may
be affected by various factors, including (but not limited to) location with respect to windows,
electrical devices and sunlight. We recommend you check the accuracy of the thermometer in its
location with your home thermometer.
symbol will show in the
4
and