Brita Redi-Twist Manual Del Usuario página 17

For Redi-Twist™ Systems USS-301
and USS-302
materials and tools needed
HOT WATER
VALVE
• Be sure cold water valve is closed.
• Disconnect sprayer from kitchen faucet connector stem. Seal off connector stem
with compression cap*.
• Assemble Faucet Neck to Faucet Base. Insert neck into top of Faucet Base and
tighten Retaining Nut until snug.
• Slip threaded stem into sink or countertop hole. Ensure faucet sits flat on top of the
sink or countertop surface.
• From underneath sink, slide metal lock washer up faucet stem. Screw faucet stem
nut up faucet stem until flush with the metal lock washer until it is slightly snug, and
ensure faucet spout is in proper position. Using fingers, tighten the nut to secure
faucet to sink.
Note: Do not tighten faucet stem nut with pliers, as it may strip the faucet stem threads.
Remove 3/8" tubing connector before assembling metal lock washer and faucet stem nut.
*This is an item that needs to be purchased at your local hardware or plumbing supply.
Sizes vary by faucet manufacturer.
Auxiliary Faucet Installation Instructions
COLD WATER
VALVE
Remove sprayer
Compression Cap
auxiliary faucet installation
Mount auxiliary faucet
Step 2
Faucet Neck
Retaining Nut
Faucet Base
Metal Lock Washer
Faucet Stem Nut
3/8" Tubing Connector
17
Version 2.0D