Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Charging the battery pack
More details can be found in WA3742's /
WA3747's manual
OPERATION
NOTE: The power nozzle has two
working modes: short lance only and
short lance used together with pressure
pressure enhancing lance.
Working mode 1
Attaching short lance to the power
nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B.
NOTE: In this working mode, the
highest pressure is 94psi. it is suitable
for light duty cleaning and watering.
Attaching the Multi-spray nozzle
NOTE: When attaching, rotating the
nozzle left and right to make sure the
nozzle fully seated into position and
gently pulling it to make sure it is
locked into position securely.
Watering (working mode 1)
Working mode 2
Attaching pressure enhancing lance to
the power nozzle
Attaching short lance to the pressure
enhancing lance
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. E, F .
NOTE: In this working mode, the
highest pressure is 320psi (WG629
models) / 335psi (WG640 models). it is
suitable for removing strong stains.
Cordless Portable Power Cleaner
Cleaning (working mode 2)
WARNING: Do not connect the
machine to water supplies
that are dirty, rusty, muddy, or
corrosive. (Including window
cleaning liquids, plant foods, or
fertilizers etc.)
FIGURE
NOTE: Not recommended for use
with salt water, immediately rinse with
fresh water for proper maintenance.
See Fig. A1
Attaching the draw hose to the power
nozzle
See Fig. A2
NOTE: After the draw hose is attached,
check the connection by gently pulling
See Fig. A3
upon the draw hose. It should not be
pulled off.
Attaching your own water hose
(optional)
1. Remove the hose adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Except for the draw hose
supplied, you can also connect the
power nozzle to your own water hose
with suitable connectors.
See Fig. B
NOTE: Check whether the filter screen
is missing before retightening the hose
adapter. When retightening the quick
hose adapter, please tighten securely.
Otherwise, it may not draw any water
for proper operation.
WARNING: It is not
recommended to connect the
draw hose to your garden hose or
your home tap.
See Fig. C
Pressure setting
Your power nozzle has two pressure
modes.
Start
See Fig. D
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level (<5ft /
1.5m), then attach the extension
lance and set it at high pressure. Do not
start working until the water
goes up along the hose and sprays out.
See Fig.
This could take up to 30
E, F
seconds or more depending on the
fresh water source.
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle
pattern according to your work. Spray
patterns 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for showering.
WARNING: Do not shift the nozzle
pattern when the tool is powered on.
o
o
o
o
, 15
, 25
and 40
are
is best
See Fig. G
See Fig.
H1, H2
See Fig. I1,
I2, I3
13
See Fig. J
See Fig. K
See Fig. L
EN
Publicidad
Tabla de contenido
Solución de problemas
