Hamilton Beach 10092 Manual Del Usuario página 5

840195500 ENv03.qxd:840124300 ENv02.qxd
To Use Steam Brush
1. With travel iron/steamer unplugged, press the Handle Release/
Lock Button (labeled PUSH on heel rest of iron) and pull up
handle until it locks into position.
2. Remove Water Tank Plug. Slowly pour 2 ounces (60 ml) of
tap water into the water tank opening up to the MAX Fill
Indicator. Replace Water Tank Plug.
3. Slide Brush Attachment over soleplate until the latch locks it
into place.
4. Make sure Dual-Voltage Switch is set to correct voltage and
then plug travel iron/steamer into power supply.
5. Turn Temperature Control Dial to desired temperature. With
travel iron/steamer resting on heel rest, allow 3 minutes for
travel iron/steamer to reach desired temperature. Do not
preheat travel iron/steamer with soleplate facing down.
6. Slide Steam Switch to the
7. Clothing should be on a hanger. Pull fabric taut. Hold
steamer upright against fabric. Press Steam Button every
3 seconds for steam.
NOTE: The Steam Brush may be used as a lint remover.
If using on delicate fabric that may snag, remove Brush
Attachment by pulling straight up prior to heating travel
iron/steamer.
8. To turn travel iron/steamer off, turn Temperature Control Dial
to O (OFF).
9. Unplug travel iron/steamer. Empty water from the travel iron/
steamer reservoir following directions in "Caring for Your Travel
Iron/Steamer." Set Steam Switch to
10. Allow to cool completely. Slide latch to unlock and remove
Steam Brush. Return handle to storage position and place
travel iron/steamer in storage bag.
9/24/10 1:48 PM
(Steam) position.
(Dry Iron) position.
8
Page 8
To Remove Lint
1. Lint and hair may be removed from fabrics with the lint pad by
brushing the pad across fabric slowly from left to right.
2. To clean lint pad, brush on scrap fabric or towel from right to
left.
Caring for Your Travel Iron/Steamer
1. The Water Tank of your travel iron/steamer should be emptied
after each use. Turn Temperature Control Dial to O (OFF). Set
Steam Switch to
steamer and hold over a sink. Turn travel iron/steamer nose
down until water tank opening is parallel with sink. Water will
run out of water tank opening.
2. To store the travel iron/steamer after it has completely cooled,
press Handle Release/Lock Button and press down handle to
storage position.
3. Put Brush Attachment over the soleplate.
4. Place the travel iron/steamer in the storage bag and store
resting on its side. Do not store travel iron/steamer laying
flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps since
these may scratch the soleplate.
2. To clean occasional buildup on the soleplate, wipe with a
sudsy cloth. Do not use abrasive cleansers or metal scouring
pads.
3. Always store travel iron/steamer resting on its side.
(Dry Iron) position. Unplug the travel iron/
9