Craftmade Crescent D52 Instrucciones De Instalación página 3

Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1 Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death. To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
2
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
IMPORTANT: If using the angle mount
method, check to make sure the ceiling
angle is not steeper than 35°. Angles greater
than 35° will require a 45° angle adapter.
3
Step 3
Check to make sure blades are
at least 30" from any
obstruction. Check downrod
length to ensure blades are at
least 7' above the floor.
Downrod Installation
(Normal Ceilings)
Downrod Installation
(Vaulted Ceilings)
30"
0.75m
Min.
84"
(2.1m)
Min.
4
Prior to securing mounting bracket, screw "J" hook (S10) into ceiling outlet
box as a secondary support means. Secure mounting bracket (#1) to the
outlet box (A) by tightening bracket screws & washers (S3) as shown. If not
mounting to an outlet box, use wood screws (S1) and washers (S3) and
mount securely to ceiling beam. Be sure at this point to insert canopy
screws (S2) in bracket.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S10)
OUTLET BOX
Ceiling
Bracket Screws
& Washers (S3)
Wood Screws (S1)
Canopy Screws (S2)
5
Step 5
Viewing fan housing and
motor from top, securely
plug the connector from the
wire harness into the wiring
harness connector (see diagram).
Locate the decorative rod
support bracket (A).
Using a decorative
rod (#7), insert wiring
harness (#11), including
steel cable, through
hole in support bracket (A)
and rod. Firmly hand
Support
Bracket (A)
tighten rod into bracket
(rod must be fully seated
into bracket). Install remaining
two rods (#7) in support brackets
(B and C)and firmly hand tighten.
Step 4
Support Beam
Outlet Box (A)
Mounting Bracket (1)
Wood Screws (S1)
Fan Housing & Motor
Decorative Rod (#7)
Wire Harness (#11)
Support Bracket (C)
Light
Socket
Support
Bracket
(B)