Residual Heat Indication; Booster Function; Timer - ILVE HVI90TC Manual Del Usuario

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are
still hot and indicates [ H ] on the display.
The symbol [ H ] disapears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put
any heat sensitive object on them . There are risks of burn and fire.

Booster function

The booster function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones works during 10 minutes with an ultra high
power.
The booster is foreseen for example to heat up rapidly big quantities of water, like nuddels
cooking.
 Start up / Stop the booster function
Action
Start up the booster
Zone selection
Stop the booster
 Power management
The hole cooking hob is equipped by a maximum of power. When the booster function is
activated, and not to exceed the maximum power, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed ( [ 6 ] or [ 8 ] ).
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all 4 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.
 Setting and modification of the "Egg Timer"
The "Egg Timer" is independent from the heating zones. If this timer is on and you stops the
hob, the "Egg Timer" will continue until the end of the time.
Action
To start:
To select the "Egg Timer"
Decrease the time
Increase the time
When the time reaches [00.] it is blinking and beeping.
Control panel
press "Booster" key
press key [ + ] or [ - ]
from the desired
heating zone
press key [ - ]
from the boosted
heating zone
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
touch the key [ 0/I ]
press once on timer key
[ - ] and [ + ] simultaneously
press on timer key [ - ]
press on timer key [ + ]
19
Display
control light is blinking
[ P ]
[ 9 ]
(example: power level 9)
Display
[ 0 ]
[00]
[30] wents to 29,28,27,
the time increases...