Allmatic MICROCAP 16 Manual Del Usuario página 5

MICROCAP 16
Control unit for awnings and rolling shutters
with the management of wireless sensors
Thank you for choosing this Allmatic product.
Please read this manual carefully before installing the product.
REMARKS
Please read this instruction manual very carefully before installing and programming your control unit.
After the installation keep this instruction in a safe place for any further consultation.
• The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced,
or without experience or knowledge, unless they could benefit through the intermediation of a person responsible for
their safety, of a surveillance or of instructions related to the use of the device.
• Children must be kept under surveillance to make sure that they do not play with the device.
• If the power supply's cable is damaged, it must be replaced by the manufacturer or by his assistance service or in any
case by aperson with similar status in order to prevent any risk.
• This instruction manual is only for qualified technicians, who specialized in installations and automations.
• The contents of this instruction manual do not concern the final user.
• Every programming and/or every maintenance service should be done only by qualified technicians.
• The installer must provide the installation of a device (es. magnetothermical switch) that ensures the omnipolar
sectioning of the equipment from the power supply.
1
INTRODUCTION
The control unit has been studied to be utilized with rolling shutters and awnings. This product drives 230V
motors in alternating current up to 500 W (max) with electric limit switches. It is pre-wired.
This control unit contains a radio receiver for the remote control by transmitters (CLARUS and B.RO) and for the
management of the KAIROS wireless climatic sensors (light, wind, rain and temperature), KAIROS DUO (light
and wind) and AXEM (wind and inclination), all with broadcast radio frequency 433.92MHz.
The control unit has been realized in small dimensions to allow the installation inside the boxes of the shutters
or outside (respecting the orientation of the control unit).
MICROCAP 16 drives a motor with a maximum working time of 2,5 minutes. The relays are activated with
a "OPEN" or "CLOSE" command from the transmitter and are deactivated by pressing any button of the
transmitter during the functioning. For example, in the case in which the awning / rolling shutter is stopped for
the intervention of a limit switch, the control unit remains on the state of opening (or closing) awning until the
reaching of the 2,5 minutes. In this time interval, 2 "CLOSE" commands will be necessary to bring the awning
on closing (because it will be necessary to pass through the STOP state).
ITA ENG FRA ESP DEU POR
6-1622108 rev1 05/03/2020 1/4