Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2
INSTALLATION
For an external installation, it is essential to respect the orientation of the control unit.
The correct installation is with the power supply cables and the motor cables getting out from the bottom as
reported on the box.
CORRECT INSTALLATION
3
CONFIgURATION AND ELECTRICAL CONNECTIONS
RADIO MODULE
RELAY 1
RELAY 2
BUZZER
LEARNING BUTTON
4
LEARNINg OF A TRANSMITTER
4.1 Learning of a transmitter through the button of the control unit
The control unit can be commanded by all the remotes B.RO 2/4WN, B.RO WALL and the CLARUS series.
Transmitter
reset
SERIE CLARUS
(the right and left keys are
not present in the CLARUS I)
2/4
Hidden
button
SERIE B.RO
ITA
ENG
FRA
UNCORRECT INSTALLATION
M
Warning: the functions up/down depend on the
orientation of the motor. If at one up control
corresponds a descent, it will be necessary to invert
the brown cable (up) and the black cable (down).
1. Press and release the learning button on the
control unit; it emits 3 beeps.
2. Press a key of the transmitter that you want to
memorize. The control unit automatically stores all
the keys and emits a long beep.
3. Release the key of the transmitter, the control unit
emits 4 beeps.
If no signal is transmitted in 15 seconds, the control
unit automatically exits from the learning mode (4
beeps).
ESP
DEU
POR
6-1622108
DOWN / BLACK
UP / BROWN
COMMON / BLUE
GND / YELLOW-GREEN
rrev1
05/03/2020
Publicidad
Tabla de contenido
