Tabla de contenido
Publicidad
Electromagnetic compatibility
i
NOTE
The ORTHOPHOS XG 5 / Ceph, ORTHOPHOS XG 3 fulfills all requirements for electromagnetic compatibility (EMC) compliant
with IEC 60601-1-2:2001.
The ORTHOPHOS XG 5 / Ceph, ORTHOPHOS XG 3 is referred to as "UNIT" in the following.
Observance of the following information is necessary to ensure safe operation regarding EMC aspects
Accessories
Designation of interface cables
PC as peripheral device.
Remote cable L17/L117 XG, 15m
Cable L25 OP-XG, 5m
Media converter
LAN-cable Kat5, 3m
2nd protective ground wire, 1.5mm
•
The UNIT may be operated only with accessories and spare parts approved by Sirona. Unapproved accessories and spare
parts may lead to an increased emission of or a reduced immunity to interference.
•
The UNIT should not be operated immediately adjacent to other devices. If this proves to be unavoidable, the UNIT should be
monitored to check and make sure that it is used properly.
Electromagnetic emission
The UNIT is intended for operation in the electromagnetic environment specified below.
The customer or user of the UNIT should make sure that it is used in such an environment.
Emission measurement
HF emission according to
HF emission according to
Harmonics
IEC 61000-3-2
according to
Voltage fluctuations / Flicker according
IEC 61000-3-3
to
22
Supplier
Siemens Fujitsu
LEONI
EFB-Elektronik
TTL-Network
51 68 963 D3348
2
58 72 648 D3285
Conformity
CISPR 11
Group 1
CISPR 11
Class B
Class A
compliant
Electromagnetic environment guidelines
The UNIT uses HF energy only for its internal function. The
HF emission is therefore very low, and it is improbable that
nearby electronic devices might be disturbed.
The UNIT is intended for use in all facilities, including residen-
tial areas and in any facilities connected directly to a public
power supply providing electricity to buildings used for resi-
dential purposes.
.
Publicidad
Tabla de contenido
