Maintenance And Repair; Warranty; Disposal And Environmental Aspects - EBARA E-SPD MT 2200 Manual De Instrucciones Y Mantenimento

MESSAGE
ALARM X13
INTERNAL ERROR

16. MAINTENANCE AND REPAIR

We recommend monitoring the frequency inverter periodically and regulating its operation.

17. WARRANTY

Failure to comply with the instructions provided in this instruction manual and/or any manipulation of the inverter
not carried out by an authorized technical service and/or the use of non-original spare parts will invalidate the
warranty and exempt the manufacturer from any liability in case of accidents to people or damage to property
and/or to the product itself.
Once the product has been received, check that it has not suffered significant breaks or dents. Otherwise, inform
the delivery person. Once the frequency inverter has been removed from its packaging, check that it has not been
damaged in transit. In the event of any damage, inform the distributor.
Check that the characteristics displayed on the rating plate are those you requested.
If fault is found which is not included in the "TROUBLESHOOTING" table, contact the nearest authorized dealer.

18. DISPOSAL AND ENVIRONMENTAL ASPECTS

To dispose of the parts that comprise the frequency converter, you must abide by the current regulations and laws
of the country where the product is used. In any event, do not throw away parts that may pollute the environment.
This symbol on the product indicates that it should not be disposed of with other household waste.
This stipulation only refers to the disposal of equipment within the European Union (2012/19 /EU). It is the user's
responsibility to dispose of the equipment by delivering it to a designated collection point for the recycling and
disposal of electrical equipment. For more information about equipment collection points, contact your local waste
disposal agency.
REASONS
There is no communication between the
control panel with the button pad and
display, and the power plate screwed
into the radiator.
Internal fault in the frequency converter.
24
SOLUTION(S)
Check that the flat cable that
communicates both electronic circuits
are well connected and tightened.
It may be due to an occasional error in
the firmware of the frequency converter
or the spot reading of a parameter
deemed to be outside of the limits. In
this case we recommend cutting the
power to the frequency converter for
a few minutes. If after a few minutes,
when the power is reconnected to
the frequency converter, the message
remains, contact your nearest technical
service.
EN