Inserting Printing Cartridge - Reiner speed-i-Jet 798 Instrucciones De Empleo

speed-i-Jet 798
1. Preparation
1.1. Commissioning
The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when the
green charge display
Insert batteries
Open battery compartment
f
Ensure correct polarity and insert batteries.
f
Close battery compartment
f
Charge batteries
Only connect the device to the PC when the PCset-Software was installed.
Installation of the PCset software installs the required USB drivers. The USB drivers are
automatically recognised and loaded when the device is connected to the computer.
The device driver installation fails if the device is connected without the PCset software
being installed.
Charging at a USB hub without dedicated power supply is not possible.
Connect the mini-USB-sockes
f
The green charging indicator

1.2. Inserting Printing Cartridge

The print-head needs to be changed when the print-out becomes weak and
incomplete.
CAUTION
Health risks if ink is swallowed.
Don't swallow!
f
Keep cartridge out of the reach of children!
f
Inserting printing cartridge
Remove protective cap
f
Open print-head flap
f
Take the new cartridge
f
4
nozzles or clip.
When using standard ink hold the small felt pad
f
4
nozzles until some ink appears on the felt.
Inserting print cartridge
f
Close print-head flap
f
9
6
goes out.
Fig. B

5
.
5
.
Fig. C

9
with the PC via the USB cable.
6
lights up.
Fig.

2
.
3
.
11
from its packaging and remove the protective film
11
.
3
.
+ +
A C E
13
that is provided, against the cartridge
14
from