Emergency Stop Switch; Start The Machine - Manual Driving; Overload - Husqvarna HTC 950 RX Manual De Usuario

HTC 950 RX
4.11.2

Emergency stop switch

The emergency stop switch, (EM-Stop) must only be used in an emergency, because it
shortens the service life of the machine's electrical components.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies. As long as the emergency stop switch is pressed in, the machine
cannot be started. Reset by turning the switch clockwise. The machine can then
be restarted.
4.11.3

Start the machine - manual driving

For a description of the control panel, see Figure 3-3, page 13.
1. Make sure the emergency stop switch has not been activated.
2. Check that the wheel lock is decoupled from the wheel before operating,
see Figure 4-3, page 19.
3. Insert the cable.
4. Start the dust extractor if dry grinding is to be done.
5. Turn the start key to the right; "On".
6. Start the grinding discs' rotation by turning the knob to "Start".
7. Set the speed for the grinding discs using the Speed knob.
8. The machine has now started.
4.11.4

Overload

If the machine is using too much power, the Overload indicator on the control panel
goes off. The machine switches off automatically after a while if this is ignored. Reduce
the speed of the grinding discs to see if the Overload indicator goes out. If this does not
help, follow the procedure for troubleshooting.
If the machine is heavy to operate, it can be due to the placing of the weights. Fold the
weights up or back to unload the grinding head.
Tip!
If the machine is heavy to operate, it can be due to the placing of the weights.
Fold the weights up or back to unload the grinding head.
5.0
Operation
29