AERMEC Srp ELESTA DOMOTESTA 300 Manual De Uso página 20

B
A
1 2 3 4 5 6 7
C
Dat.
Dat.
24
2
22
20 4
18
6
16 8
14
10
12
D
Service
K
1-7 N
1
1 2 3 4 5 6 7
Dat.
E
F
Dat.
24
22 2
20 4
18 6
16 8
14
10
G
12
H
Service
K
1-7 N
5
20
BOILER TIME SWITCH PROGRAM CHANGE/SETTING
-3 +3
PC-Sercvice
2
-3 +3
PC-Sercvice
3
4
To access the boiler time switch program setting function, press
( ) until it is placed next to the icon shown in the figure; when this
key is pressed, the (A) signal symbol will be displayed to the right
of the function printed on the left side of the regulation; after this,
remember that each time the key is pressed, the cursor will move
to the next function. To exit the function selection mode, scroll the
cursor up to the last function (service) and press the navigation key
again. The (D) symbol identifies the circuit that is being changed or
set; to go from one circuit to the other, press the corresponding key
(D); remember that the standard module can operate two circuits
at most; but in the case that only one circuit has been included, it will
not be possible to select circuit 2.
The time switch program function allows to set the bands within the
day in which the unit operation is established in programming phase;
such bands can be set for each day of the week, to go from one day
to the next, press ( ), every time it is pressed, the (B) cursor will
1-7
move.
Once the day in which the time bands to be programmed is selected
(key 2), it will be possible to modify the time bands; the following infor-
mation will be displayed on the screen:
E = Time band start time;
F = Time band end time;
G = Time specified for the set limit (band start or end);
H = Index that indicates whether the time band start or end is being
set (the start time is always represented by an odd-number, while the
end time, by an even number;
To modify the start or end time values, press (
desired time is selected, press (
start time has been set, it will go to the end time; if the end time has
been set, it will go to the next band, as long as its extension, added to
the previous band, is below 24 hours); once the time switch program
start and end times have been modified, press (
change of the next day.
Remember that there is a copy and paste mode that can be used
to copy the values corresponding to the time bands from one day to
another:
• Using ( ), place the (B) cursor on the day from which the time
1-7
values are to be copied and press
• Using always ( ), place the (B) cursor on the day to which the
1-7
time switch program is to be copied and press (
Remember that if the key is held down (for at least 5 seconds), the
time band standard programming will be activated;
) or ( ); once the
) to go to the next value (if the
N
) to go to the
1-7
, COPY will be displayed;
);