Before You Begin; Package Contents; Hardware Overview - D-Link DGS-1010MP Guía De Instalación Rápida

Tabla de contenido

Publicidad

Before You Begin

This Quick Installation Guide gives you step-by-
step instructions for setting up your DGS-1010MP
10-Port Unmanaged Gigabit PoE Switch. The model
you have purchased may appear slightly different
from the one shown in the illustrations. For more
detailed information about the switch, please refer
to the User Manual.

Package Contents

This DGS-1010MP package should include the
following items:
1 x DGS-1010MP
1 x Power cord
1 x Power cord retainer
1 x Rack mount kit and rubber feet
1 x Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link reseller.

Hardware Overview

LED Indicators
1
2
Figure 1
#
LED
Status
Solid
The device is powered on.
green
1
Power
Off
The device is powered off.
Indicates that the total PoE power output
Solid
of the switch has exceeded the Guard
amber
Band threshold of 118 W, but is still below
the total budget of 125 W.
PoE Max
2
The total PoE budget of 125 W has been
Blinking
exceeded and no additional devices can
amber
be powered through the switch.
The total PoE power consumption is below
Off
the 118 W Guard Band threshold.
4
3
Description
#
LED
Status
Solid
There is an active link negotiated at 10/100
amber
Mbps on this port.
Blinking
There is traffic on the port at 10/100 Mbps.
Link/Act/
amber
Speed
3
(Ports 1
Solid
There is an active link negotiated at
to 10)
green
1000 Mbps on this port.
Blinking
There is traffic on the port at 1000 Mbps.
green
Solid
The port is providing power to the
green
connected PoE-powered device.
Indicates a PoE-powered device is
PoE
Blinking
connected to this PoE port, but the switch
4
(Ports
amber
has insufficient remaining power budget
1 to 8)
to power the device.
There is no PoE-powered device
Off
connected to this port.
Table 1
Front Panel Connectors
1
Figure 2
#
Item
10/100/1000 Mbps PoE-capable ports for
1
Ports 1 ~ 8
connecting Ethernet devices and PoE-
powered devices.
10/100/1000 Mbps Ethernet uplink port
2
Port 9
for connecting to another switch using an
Ethernet cable.
100/1000 Mbps SFP uplink port for installing a
Port 10
3
compatible SFP transceiver.
Table 2
Rear Panel Connectors
1 2
Figure 3
#
Item
This is used to connect the power cable to the
1
Power Input
switch.
Power Cord
This is used for securing the power cord
2
Retainer Slot
retainer to the switch.
Switch GND
3
This is used to connect the switch to ground.
Kensington
This is used to attach a Kensington security
4
Lock Input
lock.
Table 3
Description
2
3
Description
3
4
Description
1

Publicidad

Tabla de contenido
loading

Tabla de contenido