Honeywell HUL430 Serie Manual De Instrucciones página 4

SETTING UP YOUR HUMIDIFIER
Unpack the Humidifier
Keep this instruction manual for reference
1
Remove packaging materials.
1. Remove twist tie and extend power cord. Place on a firm, level, water resistant surface a minimum of 12"
(30cm) from any walls.
Hard Water and White Dust
High mineral content in your water, also known as hard water, may cause a white mineral residue to accumulate
on surfaces in the room near the humidifier. This mineral residue is commonly referred to as white dust. The
higher the mineral content (hardness) of your water, the greater the potential that an ultrasonic humidifier
may produce white dust.
White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals suspended
in the water you are using.
FILLING / REFILLING
NOTE: Tank should be carried using two hands; one hand on the Tank Handle and the other supporting the
bottom of the Tank.
Kaz USA, Inc. will not accept responsibility for property damage caused by water spillage.
This humidifier holds 1.25 gallons (4.5 liters) of water (tank and reservoir combined).
1
Filling
1. Remove Water Tank and turn upside down. Remove Tank Cap by turning counter clockwise (left). Fill Tank
with cool water. DO NOT fill with warm or hot water.
2. Securely replace Tank Cap, aligning arrow to lock symbol.
3. Place Tank in humidifier Housing. Water will drain from the Tank into the Reservoir when the Plunger
is engaged.
4. When the Tank is empty, the humidifier will shut off and the refill light will turn on. Refill the tank following
the instructions above.
2 3
4
4