Blackstone 1923 El Manual Del Propietario página 23

TROUBLESHOOTING
S T E P 2 9
Insert two (2) #2032
Section 01
cell batteries (not included) into the
battery socket with the positive "+" BAT TERY POWERED IGNITION
terminal facing inside.
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignition button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
S T E P 3 0
Use the two (2) M3x8
screws to reattach the base.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
S T E P 3 1
Install the five (5) control knobs by pushing them into place in
01. Dead battery or no battery.
the OFF position. Insert one (1) AA battery (not included) under the igni-
tion button.
02. Battery installed incorrectly.
03. Igniter wire misaligned.
04. Damage to the ignition system.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES
05. Burner tubes are not receiving fuel.
Assembly Guide
Troubleshooting
+
" "
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the igniter wire is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
| Owner's Manual | Model 1923
-
" "
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
19