Publicidad
Idiomas disponibles
Idiomas disponibles
Mio 30 instructions for use
Read all instructions carefully before using Mio 30. Consult your pump user guide before
connecting Mio 30 to your pump. Follow proper hygiene procedures. If you are using Mio 30
for the first time, do the first set-up in the presence of your healthcare professional.
Contents
A. Lid
B. Needle guard
C. Soft cannula
D. Tape
E. Cannula housing
F. Site connection
G. Tubing connector
H. Introducer needle
I. Insertion device
J. Sterile paper
K. Finger grips – for
L. Release buttons – press here
holding Mio 30
when releasing Mio 30
M. Disconnect cover
N. Protective cap for site
connection
4 4
Mp6026020-22A1_a.indb 4
Inserting Mio 30
Unfold the front cover of this booklet to
view images that are keyed to the steps
below.
CAUTION: Check the tamper-proof seal and
sterile paper. Do not use if the seal or paper
has been broken.
1. Wash your hands before inserting Mio 30.
2. Select an infusion site on a
3. Clean the area of insertion with
O. Legs
P. Spring with finger loop
(inside)
4. Connect the tubing to a filled reservoir.
5. Remove the protective cap of the site
recommended area (shown in gray).
Refer to your healthcare professional or
pump user guide for instruction about
infusion site rotation.
a disinfectant as directed by your
healthcare professional. Be sure the area
is dry before inserting Mio 30. If needed,
remove hair around insertion site to
prevent improper attachment of the tape
to the skin.
IMPORTANT: Make sure there is no
liquid inside the tubing connector or on
top of the reservoir. If this occurs, start
over with a new reservoir and infusion set.
connector. Fill the tubing until insulin
1/29/2015 6:29:51 PM
drips
no a
your
proc
6. Pull
7. Pull
the s
8. Hold
the li
CAU
touch
the in
in the
point
injury
9. Plac
each
your
until
guar
or be
10. Imm
remo
the t
need
11. INSE
the t
on th
Publicidad
