Electrical Connection; Control Panels - Cata ESD Manual De Instalación, Uso Y Mantenimiento

DECORATIVE EXTRACTOR HOODS
Dear client,
We are sure that the purchase of our extractor hood will fully satisfy all of your needs.
Please read this instruction manual carefully in order to obtain the best results from the use of the hood.
INSTRUCTIONS FOR INSTALLATION, MAINTENANCE AND USE
General indications
Before installing and using the hood, be sure that the voltage (V) and the frequency (Hz) indicated on the feature plate match
the voltage and frequency at the installation site.
The feature plate and technical data are shown on the inside of the product.
For better performance in extracting fumes we advise that tubing installed should be of a diameter not less than 120 mm. We
also advise using rigid PVC tubing.

ELECTRICAL CONNECTION

Connect the cord to a socket or double pole switch, which must have a minimum contact opening distance of 3 mm.
The manufacturer shall not be liable for failure to observe all safety regulations in force for the correct and normal operation of
electrical parts.

CONTROL PANELS:

All of the figures of the control panels can be found on the penultimate page.
Slider control panel
This panel is located on the lower part of the hood and includes:
- 4 position motor control switch (OFF, 1
- Motor control light (Ref. B).
Light switch (Ref. C).
-
Electronic switch control panel
This panel is located on the front part of the hood and includes:
- 3 position motor control switch (1st, 2nd, and 3rd speed) (Ref. D).
- Lighting control lamp. Fig. 6. (Ref. E).
Motor control lights. (Ref. G).
-
Light switch (Ref. F).
-
TIMING: To operate the canopy timer, having selected the speed, press the button for two seconds until the LED light blinks.
The timer will then work for 15 minutes.
At the end of this time, the motor will stop and the light will go out. If it is still on, and you wish to cancel the timing, press the
timer button once and the motor will stop.
Four-speed control panel with digital indicator
This panel is situated on the front of the extractor and includes:
- Button for the light (ref. K).
On/off button of the motor (ref. L).
-
Button for reducing the motor speed (ref. M).
-
Motor speed indicator (ref. N).
-
- Button for increasing the motor speed (ref. O).
- Button for directly activating the TURBO speed of the motor (ref. P).
Button for setting the timer of the motor (ref. Q).
-
The extractor will operate for 5 minutes at the current speed and 5 minutes at each of the lower speeds until coming to a
complete stop.
Five-button control panel
This panel is situated on the front of the extractor and includes:
3 control switches for the motor (speed positions 1, 2 and 3) (ref W)
-
Off button of the motor (ref V)
-
On/off light of the motor (ref T)
-
- Light switch (ref. U)
Mechanical push Four-button control panel:
This panel is located on the front part of the hood and includes:
3 position motor control switch (1st, 2nd, and 3rd speed) (Ref. H).
-
- Motor control light (Ref. I).
- Light switch (Ref. J).
NOTE: To operate at the 2nd and 3rd speeds, the first speed must be activated.
GB
st nd rd
, 2 and 3 speed positions) (Ref. A).