Publicidad
Idiomas disponibles
Idiomas disponibles
#2. Instalación del conjunto biela derecha.
*
SOLO NECESARIO CON
CUADROS BB30 Y BBRIGHT
CA (EL RODAMIENTO SE
INSTALA DIRECTAMENTE
EN EL CUADRO).
EN CUADROS PRESS FIT 30
Y BBRIGHT LA CAZOLETA
S U S T I T U Y E
A L
RODAMIENTO Y SELLO.
CIRCLIP
(No incluido. Solo necesario
para cuadros BB30)
#3. Fijación del conjunto biela derecha.
Apriete el tornillo de la biela derecha a 35 Nm
usando una llave allen dinamométrica de 8mm.
Página 2
!
Engrase
el cono
del eje
*
SELLO
Ancho 1.6mm
(No incluido)
*
RODAMIENTO
30x42x7
(No incluido)
ESPACIADOR
11.5mm
Allen 8mm
35 Nm
MAS (Micro Adjustment Spider) SETTING (Cont.)
In some OCP+1/2 settings one bolt is hidden under the crank arm, use
the "eight shaped" nut to fix this bolt as follows:
#1 Place the "eight shaped" nut into the proper Q-Ring hole.
Do not pass the nut through any spider hole.
#2 Slide the Q-Ring over the spider until the nut is placed under the crank arm.
Ensure "OCP+1/2" arrow in the spider is pointing at the OCP hole center
desired in the ring.
#3 Slide the "eight shaped" nut into the spider hole under the crank arm.
#4 Fix the 4 chainring bolts not hidden by the crank arm.
#5 Thread the 5th chainring bolt from chainring inner face locking "eight
shaped" nut.
The marked holes with arrow peaks (
PLACEMENT" positions for "OCP +1/2" settings.
Check that bolts are placed in those positions after OCP+1/2 installation,
if not you must repeat step installation #1 to #5 again.
▲
) are the "ALTERNATIVE BOLT
Page 5
Publicidad
