Conceptronic CMED2PLAY Guía De Instalación Rápida página 24

ENGLISH
5. HOW TO USE THE GRAB'N'GO MEDIA PLAYER
5.1 OTG (On-The-Go) Mode
The HDD video player can be used as a USB host that allows you to transfer data on USB
slave devices (Digital cameras, flash disk/MP3, memory card readers, etc) directly to the player
without using a PC.
Connecting with USB devices (illustrated with digital camera)
Instructions:
1. Plug the power adapter into a working electrical outlet and connect the other end of the
adapter to the device, switch the device on.
2. Connect the OTG cable to the device, the OTG LED on the front panel blinks once
indicating it is in OTG mode.
3. Connect the other end of the OTG cable to slave USB devices (i.e. Digital Camera); some
slave USB devices may need to be turned on manually. In general, the slave USB device
has an indicator to show that it is connected properly to the host (the device).
4. Press the COPY button to start file transmission. Files on the slave USB device are
copied to an auto-created folder (i.e. DSK00000) within the first partition of the device.
While the file transmission is in progress, HDD LED is blinking. The process is
successfully completed when the HDD LED is off. When the ERR LED turns red it means
that the file transmission failed or the slave USB device is not compliant with the device. If
the ERR LED turns orange than the copy process failed. If the ERR LED turns red it is
indicating that the Hard Disk is full
5. Disconnect the USB device and OTG cable after the file transmission is complete.
Notice:
If your camera does not need drivers when you connect it to your computer and you can
retrieve images, than it is almost certain you can use your camera together with our
Conceptronic CMED2PLAY (camera must support Real USB Specification: USB 1.1. or USB
2.0 Mass Storage Specification.
24