Hunter 90121 Manual Del Usuario página 6

ASSEMBLY
14. While supporting the fan mo-
tor with one hand, loosen the
ad just ment grip on the pole by
turn ing counter clockwise and
raise the top pole slightly. Twist
the grip clockwise to stabilize
the pole.
15. Locate the plug connector in the
top of the telescoping pole and
the plug connector from the fan
motor.
16. Hold the fan motor over the
tele scop ing poles and connect
the plugs. See Figure 5.
17. Lower the motor over the tele-
scop ing poles aligning the three
Grille
Ring
Ring
Ring
Tabs
Screws
Hunter Logo
6
41746_CentFan_04.29.05.indd 6
CONTINUED
Front Blade
Assembly
Grille
Tabs
Tabs
FIGURE 5
holes in the fan motor mount
with the three in the poles.
CAUTION: Make sure that all
wires remain inside the pole.
18. Install the 35mm motor mount-
ing screw through the pole and
motor mount placing the head
of the screw in the in dent ed
area on the mo tor mount and
se cure ly tighten.
19. Install a setscrew into the re-
main ing hole and tighten.
20. Remove the mounting screw on
the upper left side of the motor
face.
Grille
Assembly
Screws
Back
Bracket
Grille
Interlock Switch
Motor Face
Motor
Shaft
Motor
Mount
Fan
Motor
Motor Mount
Setscrew
35mm
Motor
Mounting
Screw
Telescoping
Pole
Adjustment
Grip
41746-01 05/02/2005
5/2/05, 10:50:58 AM