Saneo JHS-A19-07KR2/E Manual Del Usuario página 47

The compressor The air conditioner is in safety mode to
does not work. prevent overheating.
The remote control is too far away from
the air conditioner.
The remote
control does not The remote control is not aligned with
work. the remote sensor on the appliance.
The batteries do not work.
E1 code is The
displayed. abnormal.
E2 code is The
displayed. abnormal.
The illustrations are non-contractual.
SELECTIVE COLLECTION OF ELECTRICAL AND ELECTRONIC WASTE
Electrical products should not be disposed of with household products. According to the
European Directive 2012/19/EU for the disposal of electrical and electronic equipment and
its implementation in national law, used electrical products must be collected separately
and disposed of at the collection points provided for this purpose. Contact your local
authorities or dealer for recycling advice.
WARRANTY TERMS AND CONDITIONS
This product is guaranteed for a fixed period of time with the distributor from the date of
purchase against any failure resulting from a manufacturing or material defect. This
warranty does not cover defects or damage resulting from improper installation, improper
use or abnormal wear and tear of the product.
The device must be returned in its original packaging and accompanied by the receipt,
subject to proper handling. Therefore, observe the operating instructions and safety
instructions given above. In addition, we cannot guarantee your device if you or a third
party has made any modifications or repairs.
pipe temperature sensor
room temperature sensor
Wait for the temperature to lower for 3 minutes,
then restart the appliance.
Bring the remote control closer to the air
conditioner and align the remote with the sensor.
Replace the batteries.
is Check the pipe temperature sensor and
associated circuits.
is Check the room temperature sensor and the
corresponding circuits.