Fueland Chain Oil - Ducati DCS4200 Manual De Instrucciones

Pay attention to the correct direction of the saw
chain.
(1) Moving Direction
(1)
5. Fit the chain cover to the power unit and
fasten the nuts to finger tightness.
6.While holding up the tip of the bar, adjust the
chain tension by turning the tension screw until
the tie straps just touch the bottom side of the
bar rail.
7. Tighten the nuts securely with the bar tip
held up (12-15N.m). Then check the chain
for smooth rotation and proper tension while
moving it by hand. If necessary, readjust with
the chain cover loose.
8.Tighten the tension screw
(2) Loosen
(3) Tighten
(4) Tension screw
NOTE
A new chain will expand its length in the
beginning of use. Check and readjust the
tension frequently as a loose chain can easily
derail or cause rapid wear of itself and the
guide bar.

6. FUELAND CHAIN OIL

Fuel
Mix a regular grade gasoline (leaded or
unleaded, alcohol-free) and a quality-
proven motor oil for air cooled 2 cycle
engines (Recommend JASO FC
Grade).
Owner's manual
Recommended mixing ratio:
Condition
Up to 20 hours use
After 20 hours use
WARNING
Keep open flames away from the area where
fuel is handled or stored.
Mix and store fuel only in an approved gasoline
container.
NOTE
Most engine troubles are caused, directly or
indirectly, by the fuel used on the machine.
Take special care not to mix a motor oil for 4
cycle engines.
Chain oil
Use motor oil SAE #10W-30 all year round
or SAE #30~#40 in summer and SAE #20 in
winter.
NOTE
Do not use wasted or regenerated oil that can
cause damage to the oil pump.
English
Gasoline: Oil
20:1
25:1
35