Ducati DCS4200 Manual De Instrucciones página 40

English
Owner's manual
Always finish cutting from the opposite side of
bending direction to prevent the guide bar from
being caught in the cut.
A Log lying on the ground (F20)
Saw down halfway, then roll the log
over and cut from the opposite side.
A Log hanging off the ground.
In areaA, saw up from the bottom one-third and
finish by sawing down from the top. In area B,
saw down from the top one-third and finish by
sawing up from the bottom.
Cutting Limb of Fallen Tree.
First check to which side the limb is bent. Then
make the initial cut from the bent side and
finish by sawing from the opposite side.
WARNING
Be alert to the springing back of a cut limb.
Pruning of Standing Tree. Cut up from the
bottom, finish down from the top.
40
use an unstable foothold or ladder.
Do not overreach.
Do not cut above shoulder height.
Always use your both hands to grip the saw.
WARNING
Before cleaning, inspecting or repairing your
unit, make sure that engine has stopped and
is cool. Disconnect the spark plug to prevent
accidental starting.
9. MAINTENANCE
Maintenance after each use
1. Air filter. Dust on the filter surface can
be removed by tapping a corner of the filter
against a hard surface. To clean dirt in the
meshes, split the filter into halves and brush
in gasoline. When using compressed air, blow
from the inside. To assemble the filter halves,
press the rim until it clicks.
NOTE
When installing the main filler, make sure that
the grooves on the filter edge are correctly fit
with the projections on the cylinder cover.
Do not