Metro GCV1100 Manual De Instrucciones página 14

27. Do not pull the power plug out
of the electrical outlet by the
power cord.
28. Connect the mains plug to an
GB
easily accessible socket, in
order to quickly disconnect
the appliance from the mains
supply in an emergency.
29. The appliance is not intended
to be used with a multi-
socket unit or an extension
cable. The power plug of
the appliance should have
its own independent and
properly grounded socket.
Using adapters may cause
overheating or fire.
30. Do not store medicine,
chemicals, hazardous or
flammable materials in the
appliance.
31. Do not place the appliance
in direct sunlight or close to
any heat sources, as this will
hinder the cooling process.
32. The refrigerant and insulation
blowing gas used in the
appliance require special
disposal procedures. When
disposing of them, please
consult your service agent or a
similarly qualified person.
33. Keep a minimum distance of
10cm between all sides of the
appliance and walls or other
objects and do not place the
appliance close to curtains.
Otherwise, cooling capacity or
ventilation may be impacted.
34. After the appliance is turned
off, always wait at least
5 minutes until turning it
on again. Otherwise, the
compressor may be damaged.
35. The appliance is very heavy. It
is recommended to slide it for
transport whenever possible.
If the appliance must be lifted,
please only do so with several
people or with machines
intended for this purpose.
Only lift the appliance from
the exterior of the base to
avoid damage. Do not move
the appliance by application
of pressure to the surface.
Never tilt the appliance more
than 45° or turn the appliance
on its side or upside down to
avoid damaging the refrigerant
circuit. The above applies
to the packed as well as the
unpacked appliance.
36. Do not apply excessive
pressure to the glass and do
not place heavy objects on
the appliance. Otherwise, the
glass may break.
37. Important! Allow the
appliance to stand upright
for at least 2 hours before
connecting it to a mains outlet
for the first time, so that the
refrigerant can settle. The
- 13 -