Front Runner FAJK007 Manual Del Usuario página 4

2 PREP FOR INSTALLATION OF INNER BRACKETS (FAJK002)
2.1
2.2
2.3
FAJK007 / FAJK008_REV_A00
4
Loosen the velcro, unzip and remove the
padding covering the roll bars.
Remove the wiring harness and plastic
clip from the roll bar.
Locate the two threaded holes on the
underside of the roll bar and fasten the
two halves of the Roll Bar Clamps (Items
3 & 4) to the roll bar using M6 x 19 x 1SS
Flat Washers and M6 x 20 Hex Bolts
(Items 7 & 10). Place the Outer Roll Bar
10mm
Clamp (Item 3) first, followed by the
Inner Roll Bar Clamp (Item 4).
Loosely attach the Rear Support Arms
(Item 1) to the outside of the Roll Bar
Clamps using M6 x 20 Hex Bolts, M6 x 19
x 1SS Flat Washers and M6 Nyloc Nuts
(Items 7, 10 & 11). Make sure the foot
10mm
faces the inside of the vehicle as shown.
Mark the position of the holes in the foot
onto the roof.
Once the holes have been marked
10mm
remove the Rear Support Arms.
Drill 4mm pilot holes on the marks you
have made.
6mm
4
13mm
© 2020 FRONT RUNNER VEHICLE OUTFITTERS