Cartridge Assembly - Horton S Instrucciones De Servicio

Fan drive and air chamber removal
11. Remove the O-ring from the Piston Friction Disc and clean the
O-ring contact surfaces.
12. Lubricate the new D (O)-ring and D (O)-ring contact surfaces
with the fresh lubricant supplied in the kit; then, install the
new D (O)-ring onto the Piston Friction Disc.
NOTE
The entire tube of the lubricant should be used when lubrica-
ting the new D (O)-rings and D (O)-ring contact surfaces. Extra
lubricant may be placed in the bottom of the Air Chamber. A
slight amount of lubricant will be needed for the O-rings on the

Cartridge Assembly.

Cartridge Assembly
Wear safe eye protection when removing Retaining Rings to pre-
vent serious eye injury.
1. Remove the Retaining Ring.
2. Remove the Cartridge Assembly and, if applicable, the U-cup.
Clean the Journal Bracket bore if necessary.
The Cartridge Assembly shown in Step 2 is an older style brass
Cartridge. The new Cartridge Assembly does not use the U-cup
Seal. Make sure you DISCARD the U-cup Seal upon installation
of this new style Cartridge.
12
WARNING
CAUTION