Reference; Connections-Balanced And Unbalanced - SKP Pro Audio SK-6P El Manual Del Propietario

SK-6P

REFERENCE

Connections - Balanced and Unbalanced
There are two basic types of audio system interconnections for audio signals: Balanced and Unbalanced. Your
SK-6P can accept either type of input.
Balanced Lines
In audio, a balanced line is a three-conductor system in which the two signal wires carry an equal, but opposite
voltage with respect to the ground wire. The ground wire acts only as a shield and does not carry any audio signal
current. Outside interference (such as RFI-Radio Frequency Interference) is either shielded from the internal signal
conductor, or if it gets into the cable is cancelled out by the opposite signals at the receiving end. Balanced
connections are preferred for any longer cable runs.
Unbalanced Lines
Unbalanced cable is a two-wire system where the shield (ground wire) acts as one of the current carrying signal
conductors. The center conductor enclosed by the shield is commonly known as the "hot" conductor. Unbalanced
audio cables do not reject noise as well as balanced lines. Unbalanced lines are typical in home hi-fi type systems
and on the outputs of electronic musical instruments. These work well if the distance between the components is
short, the signal level is relatively high and all of the electronics used in the system are same AC service.
Unbalanced Sources to SK-6P Powered Loudspeakers
If you need to connect your SK-6P speakers to an unbalanced source you have two options:
Use the LINE 2 and LINE 3 connectors. These inputs are balanced but will accept unbalanced inputs without the
need for any special adapters.
Use an adapter or special cable (see the section "Cables and Connectors")
9
REFERENCE