Mix/Loop; Controls - SKP Pro Audio SK-6P El Manual Del Propietario

SK-6P

MIX/LOOP

This switch selects the source of the signal, for the OUT connector.
CAUTION: Before adjusting this switch, be certain to set the input level control of any equipment connected to this
output to its minimum gain (least sensitive) setting.
In the disengaged position, only the signal from the INPUT1 connector is routed directly to the OUT connector. Chang-
ing the other settings on the audio panel will not effect the OUT signal. The INPUT 2 and INPUT 3 inputs will not be
present at the OUT connector. Use this setting when you want to feed multiple SK-6P powered speakers the same
signal.
In The MIX position (depressed), a post-EQ blend of all inputs to the speaker(INPUT1,2, and 3)will be sent to the OUT
connector, Any changes to input level settings or EQ will affect the OUT signal, See the SYSTEM EXAMPLES section
for details on how this mode may be used.

Controls

INPUT 1
Adjusts the level of INPUT 1. Use this control to match the input sensitivity of the SK-6P to the output level of the mixer,
microphone,or instrument connected to INPUT1.It is a common misconception that this control changes the power of a
system. Your SK-6P will produce its rated output power no matter where this control is Jset. The INPUT 1 control
Determines how much signal is required at the input in order to drive the system to full output.
INPUT 2 & INPUT 3
These controls adjust the level of the inputs connected to INPUTS 2 and 3.
LF EQ
This control allows up to 15dB of cut or boost at 75 Hz. If the system seems too "boomy" or bass heavy, rotate this con-
trol counter clock-wise. If the system sounds too "thin" or lacks low-end power, rotate this control clock-wise. To set the
low-frequency EQ to "flat" (no EQ cut or boost), set this control to the center detented position.
HF EQ
This control allows up to 15dB of cut or boost at 30KHz. If the system seems too "strident" or "tinny", rotate this control
counter clock-wise. If the system sounds too "dark" or lacks "brilliance", rotate this control clock-wise. To set the low-
frequency EQ to "flat" (no EQ cut or boost), set this control to the center detented position.
CONTROLS AND CONNECTIONS
5