DeWalt DWE6000 Manual De Instrucciones página 37

FIG. 8
R
Direction of Feed (Fig. 9)
The direction of feed is very important when trimming and can
make the difference between a successful job and a ruined project.
The figures show the proper direction of feed for some typical
cuts. A general rule to follow is to move the laminate trimmer in
a counterclockwise direction on an outside cut and a clockwise
direction on an inside cut.
FIG. 9
S
T
1
2
4
3
35
SHAPING THE OUTSIDE EDGE OF A PIECE OF STOCK
1. Shape the end grain, left to right
2. Shape the straight grain side moving left to right
3. Cut the other end grain side
4. Finish the remaining straight grain edge
NOTE: Make several light passes instead of one heavy pass for better
quality work.
Troubleshooting
For assistance with your tool, visit our website at visit www.dewalt.com
or call 1-800-4-D WALT (1-800-433-9258) .
E
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.