Installation Instructions - ITW TERRA-S Manual De Usuario

INSTALLATION INSTRUCTIONS

Repairing a flat tyre with a TERRA-S Standard Kit is simple and takes only 12 minutes.
1. Start by rotating tyre so that the valve stem is in the upper half of the tyre.
2. Slowly remove the valve core with valve core tool provided. Take care to keep a hold of the
valve core as remaining pressure in the tyre can cause the core to shoot out.
3. Allow the tyre to fully deflate.
4. Remove the puncturing object if possible.
5. Shake the bottle. Place white cap on sealant bottle. Attach filler tube to the bottle tip and tyre valve
stem and squeeze in whole bottle content of TERRA-S Tyre Sealant.
6. Replace the valve core.
7. Inflate the tyre.
STEP 1
Screw on air hose onto
valve stem.
*NOTE: Correct tyre pressure can be found in vehicle owner's manual or on driver's side door jamb.
8. Immediately after inflating, drive for 2mi (3km) and stop to verify that the puncture has been sealed.
Check tyre pressure. Reinflate if necessary. Apply the provided sticker to your windshield to remind you
not to overspeed until you reach home or a workshop to have your tyre professionally repaired. Drive
under 50mph (80km/h) to avoid vibrations caused by the presence of sealant in your tyre.
NOTE:
Introducing a liquid in a tyre provokes vibrations at certain speeds, according to general physic
laws. If you experience vibrations while driving after the repair, slow down.
1
5
Plug power cord into power
outlet receptacle.
2
6
STEP 2
3
Max. 10 Min.
7
STEP 3
Turn on inflator and when proper pressure is
reached, turn off inflator, unplug power cord
and remove connector.
4
Minimum Pressure
1,3 bar 19 psi
1,8 bar 26 psi
1 bar
-
Min.
14 psi
8
1 bar
Min. -
14 psi