Tabla de contenido
Publicidad
How to install the Base using the LATCH SYSTEM
Close the Right Tight lockoff
clip by pressing the lever as
shown in the picture with an
audible click.
Now check the level indicator
again. It is divided in 3 areas that give the
proper backrest angle depending on the
weight of your child. Make sure that the
bubble is in the selected area.
Important! If the base is used without
the load leg, leave the load leg tucked
under the base and install it using latch
only as explained in the previous section.
Now that you have installed the base, go
to page 37.
- 31 -
Publicidad
Tabla de contenido
