Spare Parts - Peltor MT7H79F-01 GB Manual Del Usuario

• For optimum protection push any hair away from your ears so that the
cushions fit closely against your head. The legs of spectacles should be as
thin as possible and lie close against your head.
• To provide maximum noise compensation the microphone must be positioned
about  mm from your lips.
• Clean the exterior of the headset regularly with soap and warm water. NOTE!
The headset must not be immersed in liquid!
• Despite its high quality the headset may deteriorate with age. You should
therefore check it regularly to make sure that there is no cracking or sound
leakage that could impair the hearing protection performance. If worn
continuously, check the cushions frequently.
• Do not store the headset at temperatures above +55 °C, e.g. on a dashboard
or windowsill!
• The product may be harmed by some chemical substances. Further
information can be obtained from the manufacturer.
C) ATTENUATION VALUES
The headset has been tested and approved to PPE directive 89/686 EEC, and
relevant parts of the European standards EN 5-:99 and EN5-6:00.
Certification was carried out by the Department of Physics, Finnish Institute of
Occupational Health, Topeliuksenkatu 4, FI-0050 Helsinki, Finland ID#040.
Key to table of attenuation values: ) Frequency in Hz. ) Average attenuation in
dB. ) Standard deviation in dB. 4) Average Protection Value.
ACCESSORIES
Throat mike MT9
Can easily be connected and used when a boom microphone is not desired.
Mike protector HYM1000
Moisture-resistant, wind-resistant and hygienic protector that effectively protects
and prolongs the life of the microphone. Supplied in 5-metre pack that is sufficient
for around 50 changes.
Wind shield for MT70 microphone M40/1
Effective protection against wind noise. Protects the microphone and extends its
life. Pack contains one wind shield.
Clean disposable cover HY100A
Hygienic disposable cover that is easily fitted over cushions. Supplied in pack
of 00 pairs.
Clip TKFL01
Can be used as required to secure connecting cable to clothing.
Storage bag for headset FP9007
Protects your headset during transport and storage.

SPARE PARTS

Hygiene kit HY79
Easily replaced hygiene kit for headset. Consists of two snap-fit attenuation
inserts and cushions. Should be replaced frequently to ensure consistent
attenuation performance and good hygiene and comfort. If worn continuously,
replace at least twice a year.
Microphone MT70
Complete microphone boom with dynamic microphone that can easily be
connected to a headset.
5