Samsung FlexWash WV60A9900A Serie Manual De Usuario página 27

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 6 Position the drain system
C
In a wall standpipe drain system
Untitled-2 27
7. Open both taps, and then check if there is a leak.
CAUTION
To prevent water hoses from being bent or kinked, make
sure there is at least a 6-inch (150 mm) space between
the washer and the rear wall.
NOTE
If you do not want to use hot water, insert the inlet cap
into the hot water inlet. You must purchase the inlet
cap. If the hot water inlet is closed with the inlet cap, you
must select Cold for the water temperature.
The pipe connector is attached on the product.
NOTE
A
A : Upper drain hose
B : Lower drain hose
B
C : Pipe Connector
The drain hose must be placed into a wall standpipe
drain system.
After inserting 2 drain hoses into the pipe connector, use
the cable tie to bind the drain hoses, and then insert the
pipe connector into the wall standpipe.
When complete, use the cable tie to bind the drain hose
to the water hose.
English 27
2021-05-17
2:04:28

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido