Kenmore Elite 51403 Serie Manual De Uso Y Cuidado / Instalacion página 10

7. Remove 3¼" x 10" vertical, 3¼" x 10" horizontal (both are the rectangular central knockout plates, see
hatched areas), or 7-inch round knockout plate as appropriate for your ducting method (see F
1 B).
F 1 A
IGURE
7" ROUND
KNOCKOUT PLATE
(
ALSO REMOVE VERTICAL
)
KNOCKOUT PLATE
3¼" 10"
X
VERTICAL
KNOCKOUT
PLATE
8. Attach 3¼" x 10" Damper Assembly on top OR back of hood (if using 3¼" x 10" duct; shaded part in F
or 7" Round Duct Plate (if using 7-inch round duct, F
3¼" x 10" damper assembly must open as shown in F
F 2 A
IGURE
3¼" 10"
X
DAMPER
ASSEMBLY
3¼" 10"
X
DAMPER
ASSEMBLY
NOTE: To accommodate off -center ductwork, the 7" round duct plate can be installed up to 1/2" on either
side of the hood center.
TIP: Insert a small length of duct over the 3¼" x 10" damper assembly (for rectangular ducting) or 7" round (for
round ducting) and seal the joint using aluminum foil duct tape to ease connection with the house ductwork.
DUCTED INSTALLATIONS ONLY
3¼" 10"
X
HORIZONTAL
KNOCKOUT
PLATE
SCREWS
SCREWS
F 3
IGURE
SCREWS
F 1 B
IGURE
3) over the knockout opening. When installed, the
IGURE
2 B.
IGURE
F 2 B
IGURE
TOP/BACK
EDGE OF
HOOD
7" ROUND
10
IGURES
DAMPER
BACK OF
HOOD
DAMPER
FLAP
PIVOT
DUCT
PLATE
1 A and
2 A)
IGURE
FLAP
PIVOT