Connecting The Power Cord - Pioneer PDP-5060HD Manual De Instrucciones

Preparation

Connecting the power cord

Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Media Receiver (rear view)
ANT/
CABLE A IN
MONITOR
OUT
INPUT 2
ANT B
I N OUT IN
R-AUDIO-L
SERVICE ONLY
CONTROL
CAUTION
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power
cord with a ground terminal is used for efficient
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
SYSTEM
CABLE
WHITE
BLACK
SYSTEM
CABLE
WHITE
BLACK
Noise filter
Partially eliminates noise caused by the power source.
S400
G-LINK
(TS)
OPTICAL
Cable CARD
R-AUDIO-L DIGITAL OUT
SUB WOOFER
INPUT 3
Y C / P C / P
VIDEO S-VIDEO B B R R
INPUT 1 INPUT 3 BLACK WHITE
COMPONENT
INPUT 1 VIDEO HDMI SYSTEM CABLE
Noise filter
Partially eliminates noise caused by
the power source.
Power cord
AC IN
AC IN
Power cord
NOTE
• Always turn off the power of the Plasma Display and Media
Receiver when connecting or disconnecting power cords.
• Disconnect the power cord from the power outlet when the
Plasma Display System is not going to be used for a long
period of time.
05
23
En