Metabo HPT M 1808DA Instrucciones De Seguridad Y Manual De Instrucciones página 16

English
(3) As shown in Fig. 21, securely attach the bottom of
the base ass'y to processed surface of the materials.
Feed the trimmer while keeping the guide plane on
the surface of the materials.
Body feed direction
NOTE
When using the straight guide, be sure to install it on
the right side in the feed direction. This will help to
keep it fl ush with the side of the workpiece.
○ By exchanging the straight guide with the guide
holder, the tool can be used for circle cutting work.
[Processing range (distance from the enter of rotation
to the center of the bit)]
Minimum: 84 mm
Maximum: 182 mm
Note that circles measuring 102 to 124 mm and
143 mm to 158 mm cannot be processed.
(1) Turn wing nut and remove the bolt and washers
(2 pieces).
(2) Reverse the top and bottom of the straight guide and
attach it to the guide holder. (Fig. 22)
Bolt
Washer
Wave washer
Wing nut
16
Straight guide
Fig. 21
Guide holder
Straight guide
Fig. 22
Depending on the radius of the circle to be processed,
the holes will vary for the wing nut and bolt.
Processing a circle with a radius of 84 to 102 mm
Wave washer
Washer
Bolt
Processing a circle with a radius of 124 to 182 mm
Center hole
(3) Installation to the tool is the same as that for straight
line processing.
(4) Align the hole of the straight guide left in the center
position of the circle processing, and fi rmly secure
with a nail less than 6 mm in diameter which will act as
a rotation axis.
Rotate the body towards the right. (Fig. 24)
Nail (rotation axis)
Wing nut
Center hole
Fig. 23
Body feed direction
Fig. 24