Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
MAINTENANCE AND INSPECTION
WARNING
Be sure to turn off the switch and pull out the battery before doing any inspection or maintenance.
1. Inspecting the bit
Continued use of a dull or damaged bit will result in
reduced cutting effi ciency and may cause overloading
of the motor. Replace the bit with a new one as soon
as excessive abrasion is noted.
CAUTION
If a dull bit is used, reactive force is increased
during cutting operation. Avoid the use of the
dull bit without repair.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are
fully tightened. Should any of the screws be loosened,
retighten them immediately.
WARNING
Using this trimmer with loosened screws is
extremely dangerous.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Check for Dust
WARNING
To prevent dust inhalation or eye irritation, wear
protective safety goggles and a dust mask when
using an air gun to clean.
Use an air gun or other similar tool to remove
materials, chips, etc. which have adhered to the body
(especially where indicated in Fig. 33), and wipe with
a soft dry cloth or a cloth moistened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for
they may damage the plastics. (Fig. 33)
22
Battery sliding grooves
Rack portion
Collet cone and Collet nut
5. Inspection of terminals (tool and battery)
Check to make sure that swarf and dust have not
collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have collected
on the terminals.
Failure to do so may result in malfunction.
6. Disposal of the exhausted battery
WARNING
Do not dispose of the exhausted battery. The
battery must explode if it is incinerated. The
battery is recyclable. At the end of it's useful
life, under various state and local laws, it may
be illegal to dispose of this battery into the
municipal waste stream. Check with your local
solid waste offi cials for details in your area for
recycling options or proper disposal.
7. Storage
Storing in a place below 104°F (40°C) and out of the
reach of children.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signifi cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
Air gun
Power button
Ventilation hole
Switch button
Fig. 33
Publicidad
Tabla de contenido
