Ickle Bubba Galaxy Manual De Instrucciones página 14

SEATBELT INSTALLATION
Important!
Do not mix up point (H-1) and shoulder strap (H-1) .
1 2
Place the baby car seat in a rearward-facing position on
the seat. The carrying handle must be locked in an upright
position (H-2).
Thread the lap section of the seat belt across the front (foot
end) between the shell and the two blue belt hooks (H-3).
Place the shoulder section of the seat belt around the baby
car seat and slide it into the blue belt hook on the back (H-
4).
Please make sure the seat belt is located between the
adapter and seat base (H-5).
The retaining hook holds the seat belt in place (H-6).
After fixing the baby car seat onto the seat of the car, push
down the red button on both sides of the carrying handle so
that it touches the back rest of the car seat (H-7).
3
Insert the tongue section into the buckle (H-8) . Make sure
the seat belt is not twisted. Tighten it as much as possible.
Check again to make sure the seat belt is threaded through
all three blue belt hooks.
NOTE: Your vehicle must be parked on a horizontal surface
during this installation.
13
V.01.20