Description; Purpose; Overview; Installation - GreenWorks G40PSF Manual Del Operador

1

DESCRIPTION

1.1

PURPOSE

The product fitted with a cutting attachment mounted on a
pole to enable the operator to cut the branches of standing
trees but not intends for cutting woods as normal chainsaw.
This appliance is not intended for use by persons (including
children) with reduced understanding, or lack of experience
and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
1.2

OVERVIEW

Figure 1-20
Small lock-out button
1
Lock-out button
2
Trigger
3
Pole saw handle
4
Collar
5
Extension pole
6
Pole saw head
7
2

INSTALLATION

2.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
2.2 ADD THE BAR AND CHAIN
LUBRICANT
Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain lubricant as follows.
English
Chain cover lock nut
8
Oil tank cap
9
10 Bar
11 Chain
12 Oil indicator
13 Chain lubricant
14 Chain cover
IMPORTANT
Use bar and chain lubricant that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
lubricant.
1. Loosen and remove the cap from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that no dirt in the
oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for 15 - 40 minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
2.3

FIT THE POLE SAW

Figure 2-3
1. Mount the pole saw head on pole saw handle to achieve
the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
2.4

EXTENSION OF THE POLE SAW

Figure 2-3
1. Fit the extension pole between the pole saw handle and
the pole saw head to achieve the maximum length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
Periodically check the tightness of the connection of the
collars.
2.5

USE THE SHOULDER STRAP

Figure 4
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
2.6

CUTTING PREPARATION

Figure 4
Before you start to cut, make sure that
5
NOTE
WARNING
EN