HAMPTON BAY 91344 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (JJ) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L shaped
slots".
□
Remove and save the two canopy screws (II) in the round
holes. This will enable you to remove the mounting bracket (A).
A
II
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrew (PP) on the collar on
top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly
(D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (CC) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (PP) on the collar on top of the fan-
motor assembly (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring (JJ).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
HH
C
JJ
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
JJ
B
F
D
C
B
F
DD
PP
D
HAMPTONBAY.COM